Ubiquiti Networks:-AirGrid M5 HP with AirGrid M5 HP (Access Point and Cpe Configuration )

AirGrid M5 HP(AP Configuration )

Models airGrid M2 HP
 Model: AG-HP-2G16 • 2412 - 2462 MHz
 • 16 dBi
• Antenna Size: 370 x 270 mm

The Device Specification.

The below picture of my Access point .

AirGrid M5 HP CPE Configuration.

Lets see the status of both AP and CPE.


AP Status.

CPE Status.

These are the basic configuration but There are some advance configuration to manage the frequency and noise in wireless network.


Lets see some of the important things .

How to change the IP address of the device.

Ubiquiti Networks:-LiteBeam 5AC 16 120 with LiteBeam M5 (Point To Multi-point )

LiteBeam 5AC 16 120(Access Point )

 Find the documentation of this device below.

https://dl.ubnt.com/guides/LiteBeam_ac/LiteBeam_LBE-5AC-16-120_QSG.pdf


How To access the Ubiquity.

Configuration:(AP)
-------------------

Wireless Mode:-I have selected as Access Point-Ptmp AiirMAX Mixed , Because my CPE's are not in AC categories of Ubiquity ,That's why  I have configured it as mixed .

SSID-Give the name of your AP name which will show you in your CPE's end to configure that CPE.And the WPA authentication should be same in both side.

NOTE:-The same SSID and password should be same  in the both side of Ap and CPE's end .

Output power selected as 20dBm.


CPE's Configuration :(LiteBeam M5)

The below picture is my CPE's configuration..
SSID,Password,WPA authintiocation should be same in AP and CPE as well.

The Device mode is configured as Station .

After Configuring the CPE devices you can see the status of CPE whether it is connected or not .
Lets check the status in main Page.

Lets check teh Status in AP and will see whether our cpe is connected or not .

Now its connected and as you can seen in my AP.

NOTE:--All the configuration are done in Latest Firmware .so if you cant see these options then you may have to upgraded the firmware .