Ubiquiti Networks:-LiteBeam 5AC 16 120 with LiteBeam M5 (Point To Multi-point )

LiteBeam 5AC 16 120(Access Point )

 Find the documentation of this device below.

https://dl.ubnt.com/guides/LiteBeam_ac/LiteBeam_LBE-5AC-16-120_QSG.pdf


How To access the Ubiquity.

Configuration:(AP)
-------------------

Wireless Mode:-I have selected as Access Point-Ptmp AiirMAX Mixed , Because my CPE's are not in AC categories of Ubiquity ,That's why  I have configured it as mixed .

SSID-Give the name of your AP name which will show you in your CPE's end to configure that CPE.And the WPA authentication should be same in both side.

NOTE:-The same SSID and password should be same  in the both side of Ap and CPE's end .

Output power selected as 20dBm.


CPE's Configuration :(LiteBeam M5)

The below picture is my CPE's configuration..
SSID,Password,WPA authintiocation should be same in AP and CPE as well.

The Device mode is configured as Station .

After Configuring the CPE devices you can see the status of CPE whether it is connected or not .
Lets check the status in main Page.

Lets check teh Status in AP and will see whether our cpe is connected or not .

Now its connected and as you can seen in my AP.

NOTE:--All the configuration are done in Latest Firmware .so if you cant see these options then you may have to upgraded the firmware .