MIKROTIK:-PPPoE configuration On Bridge Interface .

There is an another features of mikrotik to run the PPPoE on bridge interface . As I discussed on my previous chapters  Bridge is just a combination of multiple port and this interface will be act a single port internally .


if you want to run multiple PPPoE server instance on different different interfaces that would be a like overhead on the router so if you want to use multiple LAN port on specific services then that would be better to configure the bridge interface using multiple ports and then after you can run the PPPoE on that bridge interface

Network Diagram Given Below .

Here , I am not going on the step by step to configure because the configuration is same as normal configuration but only you have to create the bridge interface before you run PPPoE on bridge Interface .


Create one Bridge and assign the ETh-1,2,3 inside that bridge .

In my above Picture I have removed the physical interface from interface list and I have assigned the bridge interface which is named as laxmi.



NOTE:- Some key points .



MTU value Should be same in all interfaces .
Speed and Duplex Should be same in all interfaces .

Note: Security issue: do not assign an IP address to the interface you will be receiving the PPPoE requests on.


You don't need to change anything at any where except these changes what I Did on my above picture .